Step 6.
On each side of the storage enclosure, fit the hook on the top of the side cover and push the
bottom of it inward to reinstall the side cover to the storage enclosure.
Figure 37. Reinstalling the side cover
Step 7.
Install the hot-swap drives that were previously removed. See "Installing a hot-swap drive" on page
56.
Step 8.
Connect all the cables and start the enclosure.
The installation of the storage enclosure is now complete.
After installing the enclosure:
• Connect the cables and start the storage.
• Configure the storage.
.
Chapter 5
Part replacement and maintenance procedures
83