Hot-Swap Drive Removal - Lenovo ThinkAgile CP Hardware Part Replacement And Component Maintenance Procedures
Hide thumbs
Also See for ThinkAgile CP:
Table of Contents
Advertisement
Removing a hot-swap drive
Use this information to remove a hot-swap drive.
Chapter 3 "Read
the
Installation
Guidelines" on
page 19
Attention:
• To ensure that there is adequate system cooling, do not operate the solution for more than two minutes
without either a drive or a filler panel installed in each bay.
• Before you make changes to the drives, back up all important data stored on them.
• If one or more NVMe solid-state drives need to be removed, disable them in the OS before removing
them.
Procedure performed by: customer or field service
To remove a hot-swap drive, complete the following steps:
Step 1.
To open the drive tray handle, press the tab.
Figure 18. Hot-swap drive removal
52
Lenovo ThinkAgile CP Hardware Part Replacement and Component Maintenance Procedures
"ATTENTION:
Static Sensitive Device
Ground package before
opening" on page 21
Advertisement
Table of Contents
