Chapter 5. Configuration Procedures; Uefi Boot Mode - Lenovo ThinkAgile VX1320 Hardware Replacement Manual

Chapter 5. Configuration procedures

The chapter contains configuration procedures used in one or more hardware replacement procedures
described in Chapter 3.
This chapter also describes procedures to configure firmware for the ThinkAgile VX1320 Appliance, VX 1SE
Certified Node models. For a complete list of settings, see the VX-CMS settings file listed on the Best Recipe
site ThinkAgile VX Best Recipe .

UEFI boot mode

Use the ASU system tool, or other means, to enable UEFI boot mode, if not already enabled.
>asu64 set BootModes.SystemBootMode "UEFI Mode"
Figure 11 shows where to change the setting from the UEFI setup page, accessed via F1 during boot.
Figure 13. UEFI Boot Mode
Select UEFI Boot Mode to ensure that "HARD DISK 0" in the boot order uses the M.2 SSD for the hypervisor
boot drive.
Use the ASU system tool, or other means, to select UEFI Boot Mode:
>asu64 set BootModes.SystemBootMode "UEFI Mode"
Alternatively, use UEFI setup page to select UEFI Boot mode:
Go to Boot Manager –> Boot Modes –> System Boot Mode. Set the mode as UEFI Mode.
Alternatively, use the XCC console to select UEFI Boot mode:
17
© Copyright Lenovo , 2019