Hot-Swap Drive Removal - Lenovo ThinkAgile CP Hardware Part Replacement And Component Maintenance Procedures

Step 2. Grasp the handle and slide the drive out of the drive bay.
Figure 19. Hot-swap drive removal
Step 3. Check the status of the RAID array to verify that slot 5 is empty:
# # / / u u s s r r / / s s h h a a r r e e / / t t a a c c p p / / l l e e n n o o v v o o / / t t a a c c p p - - n n v v m m e e - - c c o o n n t t r r o o l l . . p p y y - - d d i i s s p p l l a a y y
Following is an example output:
discovering NVMe disks. this operation will take a few seconds.
Chassis UUID: 500e0eca08057b00
Number of canisters: 2
This is the bottom (primary) canister and has the controller id 33
The top (secondary) canister has the controller id 34
This chassis has the following controller ids: 33 , 34
NVMe devices: 7
----------------
NVMe control device: /dev/nvme0
Slot: 8
Manufacturer: SAMSUNG MZWLL800HEHP-00003
Serial number: S3HCNX0JC02194
Firmware: GPNA9B3Q
Capacity: 800166076416 bytes 800.166076416 GB
Drive Temp: 42 C
Drive Health: Ok
Total namespaces: 1
Namespace id(s): 1
Namespace 1 size: 794996768768 bytes, 794.996768768 GB
Namespace 1 is attached to controller id(s): 33
.
Chapter 5 Part replacement and maintenance procedures
53