Sliding The Drive Into The Drive Bay - Lenovo ThinkAgile CP Hardware Part Replacement And Component Maintenance Procedures

Step 2. Slide the drive into the drive bay until it snaps into position.
Figure 21. Sliding the drive into the drive bay
Step 3. Close the drive tray handle to lock the drive in place.
Step 4. Check the drive status LED to verify that the drive is operating correctly.
• If the yellow drive status LED is lit continuously, that drive is faulty and must be replaced.
• If the green drive activity LED is flashing, the drive is being accessed.
Step 5. Continue to install additional hot-swap drives if necessary.
Step 6. Check that the new drives are detected by the storage block:
Check that the NVME namespace to verify that nvme3 appears:
# # l l s s - - l l / / d d e e v v / / n n v v m m e e
Following is an example output:
crw-------. 1 root root 243, 0 Aug 20 11:02 /dev/nvme0
crw-------. 1 root root 243, 1 Aug 20 11:02 /dev/nvme1
crw-------. 1 root root 243, 2 Aug 20 11:02 /dev/nvme2
crw-------. 1 root root 243, 3 Aug 20 12:32 /dev/nvme3
crw-------. 1 root root 243, 4 Aug 20 11:02 /dev/nvme4
crw-------. 1 root root 243, 5 Aug 20 11:02 /dev/nvme5
crw-------. 1 root root 243, 6 Aug 20 11:02 /dev/nvme6
crw-------. 1 root root 243, 7 Aug 20 11:02 /dev/nvme7
The output show that nvme3 is present in the NVME namespace.
.
Chapter 5 Part replacement and maintenance procedures
57