Hot-Swap Power Supply Removal - Lenovo ThinkAgile CP Hardware Part Replacement And Component Maintenance Procedures
Hide thumbs
Also See for ThinkAgile CP:
Table of Contents
Advertisement
Procedure performed by: customer or field service
Complete the following steps to remove a hot-swap power supply:
Step 1.
Disconnect the power cord from the connector on the back of the power supply.
Step 2.
Press and hold the orange release tab to the left.
Step 3.
Grasp the handle and pull the power supply out of the bay.
Figure 43. Hot-swap power supply removal
The removal of the hot-swap power supply is now complete.
After you remove the power supply:
• Install a new power supply unit. See "Install a hot-swap power supply" on page 97
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
96
Lenovo ThinkAgile CP Hardware Part Replacement and Component Maintenance Procedures
Advertisement
Table of Contents
