GE Fuji Electric AF-300ES Instructions Manual page 90

LCD
GRAPHIC
FUNCTION DISPLAY
* 79 BRIGHTNESS
* 80 81-94
* 81 MTR SOUND
82 RESTART t
83 FALL RATE
* 84 AUTO-RESET
WARNING: Personal safety must be considered when activating
this function.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SETTING
LCD GRAPHIC DISPLAY MONITOR BRIGHTNESS
1 TO 10 Bright (1) to Dark (10)
FUNCTION CODE BLOCK DISPLAY
This setting determines whether or not
Function Codes 81 through 94 will be
displayed and available for adjustment.
0: Function Codes 81 through 94 NOT displayed.
1: Function Codes 81 through 94 displayed.
MOTOR SOUND
Allows the selection of the carrier freq-
uency that determines the quality of the
sound produced by the motor.
0 TO 10 Low carrier (0) to High carrier (10)
RESTART TIME
Time from frequency output reaching zero to
frequency output restarting.
See Function Code 10 (Restart)
0.0 TO 5.0 Time in seconds
RATE OF FALL
This Function Code sets the deceleration rate
for the motor during lead-in when Function
Code 10 (RESTART) is active and a momentary
power failure occurs.
0: Deceleration occurs for the set decel time.
1 TO 100 Deceleration occurs for the value set in
Hz per second.
AUTOMATIC RESET TIMES
Selects the number of times the drive
will attempt to reset after a fault condition.
0 TO 7 Reset after overcurrent, overvoltage, low
voltage, overheating and overload faults.
6-32
DESCRIPTION
FACTORY
SETTING
5
0
0
0.1S
(30HP and less)
0.5S
(40HP and greater)
10.00
0