GE Fuji Electric AF-300ES Instructions Manual page 9

Table 1: AF-300E$ – Standard Specifications
Environmental Conditions
Enclosures
Installation Location
Stored Temperature
Ambient Temperature
Humidity
Vibration
Cooling Method
Output
Rated Output Voltage
Frequency Range
Overload Current Rating
Power Supply
Rated Input AC Voltage
Control System
Momentary Voltage Dip
Starting Torque
Carrier Frequency
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
NEMA 1 Standard
Suitable for indoor mounting only, less than 1000 meters (3300 feet) elevation, not in
contact with corrosive gas, oil mist, dust, and out of direct sunlight.
-20° to +65°C (-4° to + 149°F)
-10 to +50 o C (+14 to +122 o F) (remove ventilation covers if temperature is over +40
o
[+104 F] up to 30 Hp; 40 Hp and above not required.)
20% to 90% relative humidity (non-condensing).
0.6G or less.
1/2 to 1 Hp – Convection
2 Hp and greater – Forced air
3-Phase, 3-Wire Type, 80-240 VAC or 320-480 VAC
(Can not exceed power supply voltage).
0 - 400 Hertz (0.2 to 60 Hz start frequency; 0.2 to 120 Hz base frequency).
Above 120 Hz, contact Company for approval of application.
– 30 Hp and lower
150% for 1 minute duration (inverse time characteristic)
200% for 0.5 seconds
– 40 Hp and greater
150% for 1 minute duration (inverse time characteristic) 180% for 0.5 seconds
– 200 to 230 VAC 50/60 Hz, 3 phase (1/2 to 30 Hp)
– 380 to 400 VAC 50 Hz, 3 phase (1 to 300 Hp) CT
– 380 to 480 VAC 60 Hz, 3 phase (1 to 300 Hp) CT
– 460-480 VAC, 60 Hz, 3 phase, 40 Hp and above, variable torque applications only
Voltage - +10%, -15%; Voltage Unbalance - Within 3%; Frequency - +/-5% Units are
dual rated Constant Torque/Variable Torque. Drive looks for a similar Volts/Hz ratio).
Sinusoidal PWM Control (or with torque-vector control.)
When the input voltage dips below 165 VAC (230V System), 310 VAC (460V system) or
400 VAC (575V System), the Drive can operate for 15 ms with 85% full load applied.
150% (when torque vector control is active.)
– 2 to 15 KHz (1/2 to 30 Hp) 230 & 460 VAC
– 2 to 10 KHz (40 to 75 Hp) – 2 to 6 KHz (100 Hp and greater)
2-3
o C