Table of Contents
Advertisement
Setting up a proprietary System
Setting up an Extended Agilent 81200 System based on Agilent E4849B/C and Agilent E4848B Mainframes
Apply AC Line Voltage to the Agilent 81200 System
1. Check that all mainframes are set to the appropriate voltage range, required in your country. The
voltage range selector is located at the rear panel. Usually the mainframes leave the factory
prepared for the correct voltage range for the country of destination.
2. Connect all mainframes and all peripherals which require line voltage to the ac line voltage.
Connect the power cord delivered to the line in connector at the rear panel of the mainframe.
Connect the other end of the power cord to an AC Line Voltage outlet which provides the required
power.
Next Step
After making all the required connections the system can be started, go to
page 43
32
"Start the System" on
Advertisement
Table of Contents
