Table of Contents
Advertisement
Setting up an Extended Agilent 81200 System based on Agilent E4849B/C and Agilent E4848B Mainframes
6. Connect the flat cables from Extender 1 and Extender 2 into the connectors on the main board of
the Agilent E4805A Central Clock module which goes into the Master mainframe.
Figure 23
Connect Flat Cables coming from Extender 1 and Extender 2
7. Carefully refit the side panel again, start with the middle screw of the three ones which are close to
the front panel. These three screws are short ones (5 mm). The other four screws are long ones
(14 mm).
8. Plug in the Agilent E4805A Clock module into its place in the Master mainframe.
9. Re-connect all clock cables which go to the E4841A or E4861A modules in the Master mainframe.
10. Now connect the two clock distribution cables which go from the Master mainframe's
Agilent E4805A Clock Module Extender Connection to Extender 1 and Extender 2 mainframes,
see next figure. The clock cable connects to Extender OUT in the Master mainframe and to
Extender IN in the Extender mainframes.
Figure 24
Clock Reference Distribution of the Extended Agilent 81200 System
Clock Distribution to
Extender 2
Setting up a proprietary System
Flat cable from
Extender 1
Flat cable from
Extender 2
Clock Distribution to
Extender 1
31
Advertisement
Table of Contents
