Chapter 4 Start The System - Agilent Technologies 81200 Installation Manual

Chapter 4
1. Switch ON all peripherals connected to the mainframe and if applicable Extenter mainframes
2. Switch ON the mainframe itself
Configured as a proprietary Agilent 81200 system (Agilent E4840A or Agilent E4849B/C), the
Windows NT automatic log-in script is enabled. After power on, you are automatically registered
as user DVT and the Windows desktop appears.
Configured as a open Agilent 81200 system you have to login as user or administrator defined for
your Windows NT operating system.
3. Select the kind of display you are using
The display driver is set to a mode that supports both CRT and the flat panel option. The resolution
is 640 x 480 pixels.
This should always be the first step after power on. Problems can arise, if you operate Windows or
the Agilent 81200 software without specifying your display.See
page 44 for more details.
4. Select the System Operating Mode
Depending on the operating modes LOCAL, CONTROLLED or REMOTE you can define which
software components need to be started.See
5. Start the system in a chosen operating mode.See
on page 48
6. Verify your system
Start the System
"Select the System Operating Mode" on page
"Select your kind of Display" on
"How to Start the Agilent 81200 User Software"
46.
43