Table of Contents
Advertisement
6. Install an additional HP I/O Library
This step is required only, if your system is based on an E4840A mainframe or an E4849B/C
mainframe equipped with the 3-slot Embedded PC Controller.
Insert the Agilent 81200 User Software CD into the CD-ROM drive. If auto start is enabled on your
system, the install shield will start automatically. Exit the Agilent 81200 installation program and
execute the following file: CD:\drivers\Hpfvxi\Hpfvxi3.exe.
Follow the instructions and leave all defaults.
7. Configure the HP I/O Library
Reboot the system and login as administrator.
Go to "Start"−>"Programs"−>"HP I_O Libraries"−>"I_O Config".
Select E4801A/E4806A if shown in the selection list, press Configure and accept all defaults. Finish
this step with OK.
If your system is equipped with an E623xA Controller, select HP-22/EXM-22 HPIB. Otherwise select
HP 82340/82341 HP-IB and press Configure.
Set the following values:
• SICL Interface Name = hpib or any preferred name
• Bus Address = 11
• Deactivate System Controller if system should be controlled via GPIB by another controller.
Finish Interface Configuration with OK.
8. Install the Agilent 81200 User Software
Insert the Agilent 81200 User Software CD into the CD-ROM drive. Execute CD:\setup.exe and
follow the instructions on screen.
A Microsoft Internet Explorer is required for on-line help. The installation procedure checks your
system for an appropriate version and suggests installing an Internet Explorer if that isn't the case.
Please follow the instructions on screen, reboot the system when it is requested and logon as
administrator again to finalize the installation.
Verify your display properties:
"Start"−>"Settings"−>"Control Panel"−>"Display"−>"Settings".
Your setting should be:
• Color Palette = 65536 Colors
• Font Size = Small Fonts
When the installation is completely done, reboot your system again.
9. First Login
If you are using a Agilent E4840A or E4849B/C System you can login as administrator or as user 'dvt'
with password 'DVT'. The user 'dvt' is factory default.
Installing/Updating the Agilent E4873A User Software
Software Installation & Update
53
Advertisement
Table of Contents
