Maintenance - Tesla RoboStar W550 Manual

3. Remove the safety suction cup and belay cable.
4. Unplug the device from the mains.

MAINTENANCE

ATTENTION!
Regular maintenance is recommended for the most efficient cleaning.
LACK OF MAINTENANCE MAY CAUSE DAMAGE TO THE DEVICE AND LOSS OF
WARRANTY.
Before cleaning and maintenance, switch off the suction with the „Switching suction On/Off (14)" up
( o ) and switch it off from the mains.
1. Turn the machine over and remove both cleaning mops. Soak them in warm water for 2
minutes, wash them by hand with mild detergent and allow to dry completely before
reconnecting.
2. DO NOT use wet scrubbing mops on the machine as it may slip through the window.
3. Regular cleaning of the cleaning mop will extend its life. If the cleaning pad is worn or no longer
fits properly in the velcro area, replace it with a new one to obtain the best cleaning effect.
4. Wipe the top cover of the machine with a soft dry cloth. Wipe the bottom of the machine, the
fan cover, the edge detection sensors and the rubber squeegee (see illustration):
Cleaning of belts
Turn the device over and push the „Switching suction On/Off (14)" down ( - ). The fan starts but
turns off after a while. Press on the Remote control
soft dry cloth. The shift of belts can be controlled by the remote control button
machine after cleaning the belts, push „Switching suction On/Off (14)" up ( o ).
and clean both belts successively with a
. Switch off the