Important Notification - Tesla RoboStar W550 Manual

REMOTE CONTROLER
The most common is „Automatic cleaning mode", which is activated by pressing the button
BEFORE FIRST CLEANING

CAUTION! The unit can clean the horizontally mounted glass, but only when using the directional
buttons on the remote control.

CAUTION! The device can clean angle-mounted glass, but may not function normally; in this
case, there should be a person nearby to assist in the event of a problem.

Do not use the device on a window with a glass thickness of less than 5 mm.
 The unit can be used for both frame and frameless windows larger than 50 x 50 cm.
 If the window is too dirty, clean a small part first and place the machine on it before starting
cleaning.
 Make sure there is at least 13 cm clearance between the glass and obstacles in the room (curtains
or furniture).
 Do not use the device upside down.
 Before using the machine on uneven glass surfaces (matt, textured, coated, patterned or coated),
please read the manufacturer's care and cleaning instructions. The manufacturer is not
responsible for damages caused by improper use on these surfaces.
 We recommend wiping the floor with clean water.

We recommend using the machine only with clean water. The detergent may cause foaming or
may cause smudges on the window after drying. If the dirt condition of the window so requires,
you can use a small amount of good quality window cleaner.

IMPORTANT NOTIFICATION!

Please always charge the internal backup battery before using the device. Without a full charge, the
robot will not work for safety reasons. Charging will be completed after approximately 2 hours and
the LED will turn solid blue.
1 Undefined (5 buttons)
2 Direction button/Manual mode
3 Start/Stop cleaning/Automatic mode
4
Cleaning the moving belt (see chapter „Maintenance")
5 Cleaning in „N" mode
6 Local cleaning (Up/Down)
7 Side cleaning (Right/Left)
8 Cleaning in „Z" mode
.