Status Led; Troubleshooting - Tesla RoboStar W550 Manual

STATUS LED

Red,
flashes
Red,
illuminates permanently
Blue,
flashes slowly
Blue,
flashes quickly
Blue,
illuminates permanently

TROUBLESHOOTING

Problem
The LED
flashes blue
while the
1 device is
sucked on the
window
surface.
The red LED is
2 permanently
on.
The device
3 moves
irregularly.
Connect the device to the mains and switch it on by pressing the
„Switching suction On/Off (14)" down ( - ).
The device may not be properly sucked into the window surface,
see the Troubleshooting table.
The backup battery is discharged, the device will not work until the
battery is charged. Charging may take 2 hours.
The device is on, ready to be sucked on the window.
The device has suctioned to the surface successfully and is ready
for cleaning.
Cause
Cleaning mops are not
correctly fitted.
An edge detection sensor
reports an error.
Window surface is too
dirty.
The battery is exhausted.
The power supply has
been interrupted.
The device has lost
vacuum.
An edge detection sensor
reports an error.
The window is too dirty.
Solution
Remove the cleaning mops and reattach
them.
Check that the cleaning mops do not
obscure the sensors.
Clean the area where you want the device
to suck in manually.
Please remove the device from the window
and charge the battery.
Plug the machine into a power outlet. Use
the directional buttons to navigate your
device to a place where you can safely
remove it from the window.
Use the directional buttons to navigate your
device to a place where you can safely
remove it from the window.
Check the sensor for obstruction.
Clean the belts, replace the cleaning mops
and start cleaning again.