Receiving And Answering Calls - Tadiran Telecom FlexSet-IP 280S User Manual

Receiving and Answering Calls

There are several ways to answer calls. Answer the call directly by using the conventional methods such as pressing the
flashing key, lifting the handset or pressing any flashing key (DSS, LOOP, Line, etc). Other options include using one
SPKR
of the state-related Coral system telephony features before you answer or diverting the unanswered call. The state related
features automatically appear, as shown in the display below:
The caller ID is displayed on the top line.
NOTE! If caller ID has been blocked (see
for incoming internal calls or # UNAVA message for incoming external calls appears on the top
line instead.
Do Not Disturb is used to send a reorder (busy) tone to the incoming call, thus avoiding answering the call.
[DND]
Once DND is activated, all incoming calls will receive reorder tones. See
Mute can be activated during ringing (before answering) so that when the call is answered your side of the
[Mute]
conversation is muted, and the caller will not hear you. When this feature is activated by the
toggle switch, a bullet appears to the left of
speakerphone and handset or headset. Press the toggle key again to reactivate the microphone.
Microphone on page
Call Forward All. Use this feature to forward all incoming calls to another destination. To operate, press
[FwdAll]
when your FlexSet is ringing and select the destination. See
[FwdAll]
Operating the FlexSet
Receiving and Answering Calls
Caller ID Control on page
caller #
↓→ DND
Mute FwdAll
[Mute]
141).
78), the # RESTRICTED message
All-E CallWt
. The mute feature deactivates the microphone for your
Call Forwarding / Follow Me on page 70
43
Do Not Disturb (DND) on page 98
on/off
[Mute]
(see Mute
FlexSet-IP 280S User Guide
.
.