Tadiran Telecom FlexSet-IP 280S User Manual page 51

Upon Hearing Busy Tone
After dialing an external destination, the following features appear on your FlexSet display when you hear a busy tone. Hang
up and dial later or press the nearby soft key to activate the required feature.
Leave Message is used when dialing network destinations and not external destinations.
[Msg.]
Use this feature to leave a "message" at a busy station. This feature lights the message waiting lamp at the
called party's station indicating that a message was left, and it leaves a simple message such as CALL
SUSAN on the destination station's keyset display. See
Camp On, also known as Call Back. Used only when dialing network destinations and not external
[CampOn]
destinations. When the network station is busy, you may request that the system automatically call you back
when the required destination number is available. See
Auto Redial is used to have the system automatically redial the unanswered destination. Further redial
[AutRdl]
options are available after activation (see
Save Number is used to save the dial number of the busy destination. The saved number can then be redialed
[Save#]
by pressing
NOTE! The saved number will remain in memory until another number is saved by repeating the above
procedure.
Operating the FlexSet
Making External Calls
OUT trunk line
USER BUSY
↓→ Msg.
Mute
from idle (see
[Redial] [Saved#]
AutRdl Save# ElapTm
Messages: Options on page 138
Calls Waiting: Receiving on page 79
.
Redial on page 164)
.
Redial on page 164)
40
.
.
FlexSet-IP 280S User Guide