Tadiran Telecom FlexSet-IP 280S User Manual page 226

The following table defines the special codes that may be used as part of the outside number.
Codes
*x
#0
#1
#2
#3
#4
#5
#6
#8
#9
**
##
NOTE! The number of digits that can be programmed, including dial codes, is limited by the Coral
(defined system-wide). If you try entering a longer digit string than allowed the system will give the
error message LENGTH EXCEEDED, and programming will stop.
Attendant Features
System Features
Delay dialing by X seconds (x = 1 to 9)
Stop dial (end of outside or network number)
Outpulsing wait period during which user is able to dial any number of digits
All digits following will be Dial Pulse
All digits following will be DTMF
Inhibits display (for Call Accounting System and key set display)
Enables display (for Call Accounting System and key set display)
Wait for second dial tone
Display '_' (for Call Accounting System and key set display)
Calibrated Opening on trunk (FlashTk)
Dial * out
Dial # out
Description
215 FlexSet-IP 280S User Guide