Storing, Recalling, Renaming, And Deleting Shots; Configuring Shot Banks - Ross PIVOTCam Control Panel User Manual

Storing, Recalling, Renaming, and Deleting Shots

Controls on the Store/Recall Shots tab enable you to store, recall, rename, and delete shots. You can also configure
shot banks and the text on shot buttons.
The following sections describe how to work with shots:
• "Configuring Shot Banks" on page 4–11
• "Configuring Shot Button Text" on page 4–12
• "Creating and Storing Shots" on page 4–12
• "Recalling Shots" on page 4–13
• "Renaming Shots" on page 4–13
• "Deleting, Restoring, and Discarding Shots" on page 4–15

Configuring Shot Banks

Shot banks are groups of 100 shots stored by the PIVOTCam Control Panel. One bank of shots is visible at a time.
You can add and delete shot banks.
To add or delete a shot bank:
1. On the Store/Recall Shots tab, tap the Config Banks and Shots button.
A configuration interface appears (Figure 4.9).
2. Tap the camera button corresponding to the camera for which you want to add or delete a shot bank.
3. If you want to add a shot bank, tap the Add Bank button.
A new shot bank button appears on the right end of the row of shot bank buttons. The shot numbers in the new
shot bank are higher than previous shot numbers.
4. If you want to delete a shot bank, tap the shot bank button for the bank, and then tap Delete Bank.
The shot bank is deleted, or all shots in the bank are emptied but the empty bank remains.
Shot buttons that contain shot data are never re-numbered. If any higher-numbered banks contain shots that are
not empty, the current shot bank remains, but all its buttons are emptied.
5. When you are finished making changes, tap the Apply button.
PIVOTCam Control Panel User Guide (1.2)
Figure 4.9 - Configuring Shot Banks
Using the PIVOTCam Control Panel • 4–11