Controlling Cameras; Panning And Tilting - Ross PIVOTCam Control Panel User Manual

4. Tap Save As.
A new empty data file is created, and is active in the PIVOTCam Control Panel.
Any changes you make in the control panel are immediately saved to the new data file.
To save all current data in a new file:
1. Tap the Config Cameras button.
The camera configuration interface appears.
2. In the data file area, tap Save As.
The Save Current Data File As dialog box appears.
3. In the File Name box, type a new name for the new data file.
4. Tap Save As.
The new data file is saved. The saved data remains active in the PIVOTCam Control Panel.
Any changes you make in the control panel are immediately saved to the new data file.
To load a data file:
1. Tap the Config Cameras button.
The camera configuration interface appears.
2. In the data file area, tap Load.
The Load Data File dialog box appears, and shows buttons for each saved file.
3. Tap the name of the file you want to load, and then tap Load.
The data file loads.
Any changes you make in the control panel are immediately saved to the data file.

Controlling Cameras

Controls on the Camera Controls tab enable you to control cameras manually.
Alternatively, you can use a joystick panel (if equipped).
The following sections describe how to use controls on the Camera Controls tab to control cameras manually:
• "Panning and Tilting" on page 4–5
• "Zooming" on page 4–6
• "Focusing" on page 4–7
• "Adjusting Exposure Settings (Iris, Shutter, Gain)" on page 4–8
• "Using the On-Screen Menu (Remote Control)" on page 4–9

Panning and Tilting

To pan and tilt a camera:
1. Tap the Camera Controls tab.
2. Tap the camera button for the camera you want to control.
Tip: The selected camera button is highlighted blue.
3. Tap the Camera Controls tab.
The Camera Controls tab includes the Pan Tilt area (Figure 4.4).
PIVOTCam Control Panel User Guide (1.2) Using the PIVOTCam Control Panel • 4–5