Table of Contents
Advertisement
I Function display (Main screen)
Status area
Task area
Information area
Position data
Software Key area
and Time area
D Status area
The current status is displayed in the Status area�
Indicator
Displayed when the Squelch function is ON�
SQL
Displayed when the Noise Blanker function
NB
is ON�
Displayed when the AGC function is OFF�
Displayed when the Noise Reduction
NR
function is ON�
• Displayed when the received audio is
recorded� (p� 17)
• Displayed when recording the received
audio is stopped� (p� 17)
Displayed when the Voice Scrambler
SCRM
function is ON�
Displayed when the Tune function is ON�
Tune
Displayed during a scan�
Scan
• Displayed when the volume is set to 1
to 20�
• Displayed when the volume is set to 0�
D Task area
The current mode is displayed in the Task area�
Indicator
Displayed while in the Standby mode�
STBY
Displayed while in the Radio Telephone (RT)
mode�
RT
L Returns to the Standby mode if no operation
occurs during the preset of time�
Displayed after making or receiving a DSC
call�
DSC/
L If the transceiver is in the Multiple Task
DSC (1)
mode, the number of the DSC task is
displayed by the indicator�
Channel area
Description
Description
PANEL DESCRIPTION
D Information area
The 9 digit MMSI (Maritime Mobile Service Identity:
DSC self ID) code and the following indicators are
displayed in the information area�
Indicator
Displayed when receiving a signal, or
when the squelch is open�
Displayed while transmitting�
• Displayed when the TX power is set to
Low/
each level�
Mid-L/
• If no indicator is displayed, the TX
Mid-H
po er is set to
• Displayed when the GPS receiver is
activated, and valid position data is
received�
• Blinks while invalid position data is
being received�
• Displayed when there is an unread DSC
message�
• Blinks when there is a new DSC message�
ispla e
en t e C
DSC setting is set to an option except
"Accept after 10 sec�"
Displayed when the internal speaker is
OFF�
D Channel area
The selected operating channel number, channel
name, and the following indicators are displayed in the
Channel area�
Indicator
Displayed when the Channel Select mode
is selected�
Displayed when the Group Select mode is
selected�
Displayed when the Clarity function is
ON� The number displays the added or
subtracted frequency�
Displayed when the e-mail channel is
selected�
L The Filter setting is also displayed�
Displayed when the Emergency FREQ
channel is selected�
• When receiving, the S meter displays
the relative signal strength�
• When transmitting, the RF meter
displays the output power level�
Displayed when a Simplex channel is
SIMP
selected�
Displayed when a Duplex channel is
DUP
selected�
USB/
AM/LSB/
Displays the selected operating mode�
AFSK/
FSK/CW
Description
ig
uto S itc
in
Description
2
2
7
Advertisement
Table of Contents
