Table of Contents
Advertisement
ECM-CX700
Item
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
RxD, TxD Active
IR Transmission Delay:
UR2 Duplex Mode
Use IR Pins
Onboard Parallel Port
Parallel Port Mode
EPP Mode Select
ECP Mode Use DMA
Watch Dog Timer Select
70 ECM-CX700 Series User's Manual
Options
Disable
3F8/IRQ4
2F8/IRQ3
Select an address and corresponding interrupt
3E8/IRQ4
for the first and second serial ports.
2E8/IRQ3
AUTO
IrDA
This item allows you to determine which
ASKIR
Infrared (IR) function of onboard I/O chip.
Normal
Hi,Hi, Hi,Lo
The item determines the active of RxD, TxD.
Lo,Hi, Lo,Lo
Enabled
The field enables or disables IR transmission
Disabled
delay function.
Select the value required by the IR device
connected to the IR port. Full-duplex mode
Full
permits simultaneous two-direction
Half
transmission. Half-duplex mode permits
transmission in one direction only at a time.
RxD2,TxD2
Select the correct setting of TxD and RxD
IR-Rx2Tx2
signals.
Disabled
378/IRQ7
Select a matching address and interrupt for the
278/IRQ5
physical parallel (printer) port.
3BC/IRQ7
SPP
Select an operating mode for the onboard
EPP
parallel port. Select Compatible or Extended
ECP
unless you are certain both your hardware and
ECP+EPP
software support EPP or ECP mode.
Normal
EPP1.9
Select EPP port type 1.7 or 1.9.
EPP1.7
1
Select a DMA channel for the port.
3
Disabled
10, 20, 30, 40 Sec.
This option will determine watch dog timer.
1, 2, 4 Min
Description
Advertisement
Table of Contents
