Table of Contents
Advertisement
3.5.1.2 IDE Adapter Setup
The IDE adapters control the hard disk drive. Use a separate sub menu to configure each
hard disk drive. The below Figure will shows the IDE primary master sub menu.
Item
IDE HDD Auto-detection
IDE Channel 0 Master
IDE Channel 0 Slave,
IDE Channel 1 Master,
IDE Channel 1 Slave
Access Mode
The following options are selectable only if the 'IDE Channel ...' item is set to 'Manual'
Cylinder
Head
Precomp
Landing zone
Sector
Options
Press Enter to auto-detect the HDD on this
Press Enter
channel. If detection is successful, it fills the
remaining fields on this menu.
Selecting 'manual' lets you set the remaining
None
fields on this screen. Selects the type of fixed
Auto
disk. "User Type" will let you select the
Manual
number of cylinders, heads, etc. Note:
PRECOMP=65535 means NONE !
Normal
Choose the access mode for this hard disk
LBA
Large
Auto
Min = 0
Set the number of cylinders for this hard disk.
Max = 65535
Min = 0
Set the number of read/write heads
Max = 255
Min = 0
**** Warning: Setting a value of 65535 means
Max = 65535
no hard disk
Min = 0
****
Max = 65535
Min = 0
Number of sectors per track
Max = 255
ECM-CX700 Series User's Manual 57
User's Manual
Description
Advertisement
Table of Contents
