Closing; Universal Garage Door Opener (Homelink®) - If Equipped; Before You Begin Programming Homelink; Erasing All The Homelink® Channels - Jeep GLADIATOR 2020 User Manual

Hide thumbs Also See for GLADIATOR 2020:
Table of Contents

Advertisement

Closing

To close the tailgate, lift upward until both
sides latch into place.
CAUTION!
After closing, pull back on the tailgate firmly
to ensure it is securely latched. Damage to
the vehicle or cargo could occur.
NOTE:
If the tonneau cover is installed, make
sure the tonneau cover is fully closed
before closing the tailgate.
Due to the presence of the Center
High-Mounted Stop Light, removal of the
tailgate is not recommended.
UNIVERSAL GARAGE DOOR
OPENER (HOMELINK®) — IF
EQUIPPED
HomeLink® replaces up to three hand-held
transmitters that operate devices such as
garage door openers, motorized gates,
lighting or home security systems. The
HomeLink® unit is powered by your vehicle's
12V battery.
The HomeLink® buttons, located on the sun
visor or the overhead console, designate the
three different HomeLink® channels. The
HomeLink® indicator is located above the
center button.
HomeLink® Buttons
To operate HomeLink®, push and release
any of the programmed HomeLink® buttons.
These buttons will activate the devices they
are programmed to with each press of the
corresponding HomeLink® button.
Before You Begin Programming
HomeLink®
For more efficient programming and accu-
rate transmission of the radio-frequency
signal it is recommended that a new battery
be placed in the hand-held transmitter of the
device that is being programmed to the
HomeLink®
system.
Make
hand-held transmitter is programmed to acti-
vate the device you are trying to program your
HomeLink® button to.
Ensure that your vehicle is parked outside of
the garage before you begin programming.
NOTE:
Erasing all channels should only be
performed when programming Home-
Link® for the first time.
If you have any problems, or require assis-
tance,
please
call
1-800-355-3515 or, on the Internet at
HomeLink.com
for information or assis-
tance.
Erasing All The HomeLink® Channels
To erase the channels, follow this procedure:
1. Place the ignition switch into the ON/
RUN position.
2. Push and hold the two outside HomeLink®
buttons (I and III) for up to 20 seconds, or
until the HomeLink® indicator light flashes.
sure
your
toll-free
47

Advertisement

Table of Contents
loading

Table of Contents