Table of Contents
Advertisement
3. Using the provided #50 Torx head driver
and ratchet, remove the Torx head screw
that secures the hard top at the B-Pillar
(near the top of the front door) on each
side.
Torx Head Screw Location — Left Side Shown
4. If equipped remove the lower interior soft
trim panel attached by hook-and-loop
fastener.
Interior Soft Trim Panel — If Equipped
5. Remove the two Torx head screws that
secure the hard top to the vehicle (along
the interior bodyside rearward of the back
doors) using the #50 Torx head driver.
6. Also remove the four Torx head screws
that secure the hard top to the back of
the cab of the vehicle using the #50 Torx
head driver.
Rear Fastener Locations
7. Locate the wire harness on the left rear
inside corner of the vehicle. To access
the harness, remove the plastic cover by
pushing on the side of the cover and
sliding it off.
NOTE:
Do not force open; this will break the plastic
cover.
Remove Plastic Cover
8. To release the wire harness, pull back on
the red latch, then push down on the
black button while pulling the harness
out.
Push Down On Black Button While Pulling
Harness Out
43
Advertisement
Table of Contents
