Table of Contents
Advertisement
CAUTION!
Do not touch the new bulb with your
fingers. Oil contamination will severely
shorten bulb life. If the bulb comes in
contact with any oily surface, clean the
bulb with rubbing alcohol.
LED Front Fog Lamp
If your vehicle is equipped with LED fog
lamps they are replaced as an assembly.
Rear Tail, Stop, Turn Signal, And Backup
Lamp
1. Remove the two screws that pass through
the bed sheet metal.
Tail lamp Screws
176
2. Pull the outboard side of the lamp rear-
ward, far enough to unsnap the two
receptacles on the outboard side of the
lamp housing, from the two plastic snap
post retainers in the outer box side panel.
3. Remove the screws from assembly
bracket to access the three bulb sockets.
Assembly Bracket
4. Rotate the appropriate socket a quarter
turn counterclockwise, then remove it
from the housing.
5. Pull the bulb straight from the socket to
replace.
Center High Mounted Stop Lamp (CHMSL)
The stop lamp is mounted on the tailgate. If
service is needed, obtain the LED assembly
from an authorized dealer.
License Plate Lamps
See an authorized dealer to replace these
LED assemblies.
FUSES
WARNING!
When replacing a blown fuse, always use
an appropriate replacement fuse with
the same amp rating as the original fuse.
Never replace a fuse with another fuse of
higher amp rating. Never replace a blown
fuse with metal wires or any other mate-
rial. Failure to use proper fuses may
result in serious personal injury, fire and/
or property damage.
Before replacing a fuse, make sure that
the ignition is off and that all the other
services are switched off and/or disen-
gaged.
If the replaced fuse blows again, contact
an authorized dealer.
(Continued)
Advertisement
Table of Contents
