Opening And Closing The Sunroof; Venting Sunroof; Opening And Closing The Power Sunshade - Jeep Compass 2023 Owner's Manual

58 GETTING TO KNOW YOUR VEHICLE
O A C T
PENING ND LOSING HE
The sunroof has two programmed open positions, comfort
stop position and full open position. The comfort stop
position has been optimized to minimize wind buffeting
when driving with side windows closed and sunroof open.
If the sunshade is in the closed position when initiating a
sunroof open or vent command the sunshade will
automatically open to the half open position prior to the
sunroof opening.
Express Open/Close
Push the switch to open and release it within one-half
second and the sunroof will open to the comfort stop
(partially opened) position and automatically stop. Push
the switch and release it again, and the sunroof will open
to the full open position then automatically stop.
Pull the switch to close and release it within one-half
second and the sunroof will completely close
automatically from any position.
During Express Open or Express Close operation, any
movement of the sunroof switch will stop the sunroof.
Manual Open/Close
Push and hold the switch to open. The sunroof will open to
the comfort stop (partially opened) position and
automatically stop. Push the switch and hold it again, and
the sunroof will open to the full open position then
automatically stop.
Pull and hold the switch to completely close the sunroof
from any position.
S
Any release of the switch during open or close operation
UNROOF
will stop the sunroof movement. The sunroof will remain in
a partially opened position until the switch is operated and
held again.
V S
ENTING UNROOF
Push and release the vent switch within one-half second
and the sunroof will move from the closed position to the
vent position. This is called "Express Vent." During Express
Vent operation, any movement of the switch will stop the
sunroof.
NOTE:
When the sunroof is in a full open or a partial open
position, Express Vent operation is not available. You must
push and hold the vent switch to cycle the sunroof from a
slide open position to the vent position. Sunroof
movement will stop if the switch is released prior to the
sunroof reaching the vent position.
O A
PENING ND
S
UNSHADE
The sunshade has two programmed open positions: half
open and full open. When opening the sunshade from the
closed position, the sunshade will always stop at the half
open position regardless of express or manual operation.
The switch must be pushed again to continue on to full
open position.
C T P
LOSING HE OWER
Express Open/Close
Push the sunshade switch to open and release it within
one-half second and the sunshade will open to the half
open position and stop automatically. Push the switch and
release it again, and the sunshade will open to the full
open position and stop automatically.
Pull the sunshade switch to close and release it within
one-half second. If the sunroof is in closed position, the
sunshade will full close automatically from any position.
If the sunroof is open or vented, the sunshade cannot be
closed beyond the half open position. Pulling the
sunshade switch when the sunshade is in the half open
position will automatically close sunroof prior to the
sunshade closing.
During Express Open or Express Close operation, any
movement of the sunshade switch will stop the shade.
Manual Open/Close
Push and hold the sunshade switch to open. The
sunshade will open to the half open position and stop
automatically. Push and hold the switch again, and the
sunshade will open to the full open position.
Pull and hold the sunshade switch to close. If the sunroof
is in closed position, the sunshade will fully close from any
position. If the sunroof is open or vented, the sunshade
will close to the half open position and stop. Pulling and
holding the switch again will close both the sunroof and
sunshade completely.