16
Screen Tab: Settings
The Parameter Table in Appendix B lists the 1600XPi Settings parameters that can be viewed in the MONITOR tab.
Example: The Settings parameter Batt Test Freq (Battery Test Frequency) can be viewed by USR (User) level and
above. However, only ADM (Administrators) and above can edit )change) the parameter value.
Each key displays a block of relevant command parameters:
Key: Cmd ID - (Range) Parameter type
ID – (000-099) UPS specific information such as serial number, software versions, installation date.
•
Input – (100-199) Input measured/calculated data such as input voltage, frequency, current, power, over-/under- voltage
•
settings.
Output – (200-299) Output measured/calculated data such as output voltage, frequency, current, power, over-/under-
•
voltage settings.
Bypass – (300-399) Bypass data such as configuration, voltage, current, power, OV detection level.
•
DC Bus – (400-499) Data such as Total voltage, rated voltage, Positive and Negative bus voltages.
•
Batt – (500-599) Battery voltage, charger status, total discharges, shutdown voltage.
•
Ctrl/Cfg – (600-699) Control and configuration list system and battery temperatures, system status, startup delay, auto-
•
transfer window, restart mode.
History – (700-799) History lists metrics like system operation time, total over loads, hi system temp.
•
Disp/Reye – (800-849) Display specific parameters like Disp. Firmware version, sleep timer, buzzer status, display
•
calibration points, and RemotEye 4 settings.
(850-859) lists the RemotEye 4 IP address, IP Mask, Status, Baud Rate, datalink status.
38
96%
100%
HOME
USR
Main
Monitor
ID
Output
DC Bus
Ctrl/Cfg
Disp/Reye
SETTINGS OPENING SCREEN
1600XPi Series UPS Installation and Operation Manual – 60616-014
INV
12:35 PM
Settings
Records
Input
Bypass
Batt
History
Debug
On-Line