If The Machine Is Not Used For A Longer Period Of Time / Disposing Of The Machine; If The Machine Is Not Used For A Longer Period Of Time; Disposal - probst POWERPLAN PP Operating Instructions Manual

Operating Instructions
PP
6.6

If the machine is not used for a longer period of time / disposing of the machine

6.6.1

If the machine is not used for a longer period of time

If the machine will not be used for more than 2 months:
•
Park the machine on even ground and in a dry place inside a hall or, if parked outside, on even ground and fully cover
with a dark tarpaulin.
•
Thoroughly lubricate all lubrication points. See "Lubrication".
•
Replace the engine oil with anti-corrosion oil.
Leave the engine to run for a few minutes to allow the anti-corrosion oil to evenly distribute.
•
Check the mixing ratio of the antifreeze and water in the coolant and adjust if necessary.
•
Top up the fuel with 10 % of anti-corrosion oil.
Leave the engine to run for a few minutes to allow the internal components of the injection system to be wetted with
anti-corrosion oil.
•
Coat the exposed piston rods of the levelling cylinders with anti-corrosion grease such as a Shell anti-corrosion grease.
•
Remove the battery, store it in a frost-proof place and regularly recharge. See "Maintaining the battery".
•
Fill the fuel tank with diesel up to the brim. See section on "Checking the fuel level".
•
Remove the v-belt and store.
•
Spray the groves of the v-belt pulleys with anti-corrosion oil.
•
Cover the exhaust pipe opening with rigid foil and seal with adhesive tape.
•
In areas with high humidity (tropical climates), top up the hydraulic fluid tank up to the brim.
Before taking the machine back into operation:
•
Remove the foil and tape from the exhaust pipe.
•
Charge and install the battery. See "Maintaining the battery".
•
Remove the anti-corrosion oil from the v-belt pulleys.
•
Fit the v-belt.
•
Adjust the hydraulic fluid level.
•
Remove the anti-corrosion oil from the piston rods of the levelling cylinders.
•
Replace the anti-corrosion oil with engine oil.
If the machine has not been used for more than 12 months:
•
Change the hydraulic fluid.
6.6.2

Disposal

Risk of environmental damage
Failure to professionally dispose of the machine at the end of its life cycle can lead to
environmental damage.
•
69 / 73
Maintenance and care
The machine must only be disposed of by a qualified disposal company.
V4 GB