Krick Fishing Cutter Antje Building Instructions page 42

Stage 4, King Pulley, Net Gallows, Shear Boards,
Parts 4.1 to 4.21
4.5
Fig. substructure
Glue parts 4.2 together. Insert the two collar shafts
(brass tubes) 4.4 into the outer holes. Place a king
pulley on the outside of the shaft. Insert the stub
shaft 4.5 into the remaining hole and attach the
2nd roller. Cover the whole with the king pulley
plate.
Fig. king pulley
Dismantle the king pulley again and paint it.
Make the two net gallows from parts 4.6 to 4.10.
4.6
4.7
4.8
Fig. Net gallows
Glue one part each 4.7 to 4.6 in the middle. Glue
the junction plates part 4.8 on the outside.
Install a pulley part 4.9 with axle 4.10 in the rear
gallows according to drawing H.
The two halves can now be glued together.
Stand Mai 2019
4.3
4.4
4.1
4.2
4.6
4.7
4.8
Seite 14
Fig. rear net gallows with recess for rope pulley
Fig. net gallows, the rear one with rope pulley
Fig. roller blocks parts
Make the two roller blocks from parts 4.13 to 4.16.
Fig. roller blocks finished
The net gallows and roller blocks can now be at-
tached to the deck. Grind the finished gallows to
match the deck by filing the gusset plates. Then
mark the contact surfaces with the gallows on the
©
Krick Modelltechnik Knittlingen
12 mm
4.15
4.16
4.13
4.14
4.13