Krick Fishing Cutter Antje Building Instructions page 33

Now push the drive unit into the hull and align it.
Turn the nut 1.21 on the shaft to the end and push
the sterntube against the nut. The stern tube
should protrude approx. 2 mm out of the hull.
1.17
1.20
Fig. drive unit placed in hull
When the drive unit is aligned, you can glue the
whole thing with Stabilit. First, seal the sterntube
in the hull well so that no water can get into the
hull. Once the glue has dried, the sterntube can no
longer move. Now you can glue the motor bulk-
head with Stabilit into the hull.
Fig. drive glued in hull
Next attach the RC board to the studs on the mo-
tor mount and glue.
Now the rudder can be installed. First shorten the
rudder blade to 62 mm.
1.7
Fig. Rudder
Push the rudder through the rudder tube and then
push on the rudder lever and tighten it.
Stand Mai 2019
For this, push the set collar 1.10 into the rudder
lever 1.9 and screw the screw 1.11 in.
File a surface where the screw contacts the rudder
shaft. Install the rudder servo as a test and bend
the rudder linkage according to the illustration and
plan.
1.16
Fig. RC board and rudder connection
1.31
Fig. rudder linkage
Mount the linkage connection to the servo arm in
such a way that it can rotate. Hook the rod with
the Z-crank into the rudder lever and push the
servo lever with the rod connection onto the rod.
Now place the servo lever onto the servo. Align the
rudder and tighten the grub screw in the linkage
connection.
As a next step, glue the battery holder 1.26 into
the hull in front of the motor.
62 mm
Fig. battery holder
Now the interior of the hull is finished. The deck
support strips, the rubbing strips and the handrails
Seite 5
1.9
1.15
1.30
1.12
1.32
1.26
©
Krick Modelltechnik Knittlingen
1.10
1.11