Krick Fishing Cutter Antje Building Instructions page 38

Finally mount the front end to the superstructure.
3.18
Fig. front end
First, glue in part 3.21 from inside. Glue the side
parts 3.18 and the front 3.19 in place.
Finally put on the cover 3.20 and the reinforce-
ment 3.22.
Fig. front end cover and reinforcement
Now paint the inside and outside of the super-
structure with clear varnish.
The window glasses can now also be glued into the
superstructure. Cut pos. 3.62 accordingly.
Assemble the steering stand from parts 3.27 to
3.31.
3.29
3.31
3.28 3.27
3.30
Fig. parts 3.27 to 3.31 for steering stand
Glue together parts 3.27 and 3.28 for the middle
section and finish with 3.29.
Stand Mai 2019
3.21
3.19
3.31
3.28 3.30
Seite 10
Then glue the parts 3.30 and 3.31 together twice
as corners and glue them to the right and left of
the middle part.
Fig. steering stand complete
Now sand everything and then prime, stain and
paint.
Glue the axle 3.61 into the steering wheel 3.60.
Fig. steering wheel and throttle lever
Make the housing of the throttle lever from a 3
mm plywood scrap.
Attach the throttle and steering wheel to the steer-
ing stand. Cut out the instruments from the decal
sheet and glue them to the steering stand.
Now slide the steering stand into the superstruc-
ture from below and place it on part 3.21 and glue
it.
Make the exhaust pipe from the parts 3.33 to 3.35.
3.33
3.35
Fig. parts for exhaust pipe
Glue the spacers 3.35 onto the exhaust pipe 3.33
at a distance of 20 mm.
©
Krick Modelltechnik Knittlingen
3.60
3.34