Auto Led And Hand Led Indications - YASKAWA HV600 Series Installation & Primary Operation

No. Name
Left Arrow Key
Up Arrow Key/Down Arrow Key
/
H
Right Arrow Key (RESET)
ENTER Key
AUTO Key
I
J
USB Terminal
K RJ-45 Connector
L Clock Battery Cover
M Insulation Sheet
*1 Refer to AUTO LED and HAND LED Indications on page 49
◆

AUTO LED and HAND LED Indications

AUTO LED
HAND LED
OFF OFF
OFF
OFF Long blink (50% duty) HAND Mode
OFF Double blink
ON OFF
Long blink (50% duty) OFF
Double blink OFF
YASKAWA TOEPC71061732E HV600 Drive Installation & Primary Operation
Moves the cursor to the left.
• Scrolls up or down to display the next item or the previous item.
• Selects parameter numbers, and increments or decrements setting values.
• Moves the cursor to the right.
• Continues to the next screen.
• Clears drive faults.
• Enters parameter values and settings.
• Selects menu items to move the user between keypad displays.
• Selects each mode, parameter, and set value.
Sets drive operation to AUTO Mode.
The drive uses the b1-01 [Frequency Reference Selection 1] and b1-02 [Run Command Selection 1] settings.
Note:
Push on the keypad to set the drive to HAND Mode before you use the keypad to operate the motor.
Insertion point for a mini USB cable. Uses a USB cable (USB standard 2.0, type A - mini-B) to connect the keypad to a PC.
Uses an RJ-45 8-pin straight through UTP CAT5e extension cable or keypad connector to connect to the drive.
Cover for the clock battery.
Note:
• The battery included with the keypad is for operation check. It may be exhausted earlier than the expected battery life
described in the manual.
• Refer to "Maintenance & Troubleshooting Manual (TOEPYAIHV6001)" for more information about replacement
procedure.
To replace the battery, use a Hitachi Maxell "CR2016 Lithium Manganese Dioxide Lithium Battery" or an equivalent battery
with these properties:
• Nominal voltage: 3 V
• Operating temperature range: -20 °C to +85 °C (-4 °F to +185 °F)
An insulating sheet is attached to the keypad battery to prevent battery drain. Remove the insulation sheet before you use the
keypad for the first time.
Table 8.2 AUTO LED and HAND LED Indications
OFF Mode
ON HAND Mode
• When the Frequency Reference is 0 or during deceleration
• During PI Sleep
HAND Mode
When you clear the Run command and enter the Run command again during the time set in C1-02 [Deceleration Time 1]
AUTO Mode
AUTO Mode
• When the Frequency Reference is 0 or during deceleration
• During PI Sleep
AUTO Mode
When an MFDI sends a Fast Stop signal to stop the drive
Function
for more information about AUTO LED and HAND LED indications.
Status
8 Keypad: Names and Functions
49