Wiring The Main Circuit Terminal Block Using Procedure C - YASKAWA HV600 Series Installation & Primary Operation

9.
Tighten the bolts to the specified torque.
10.
Put the terminal cover back in its initial position.
■

Wiring the Main Circuit Terminal Block Using Procedure C

Main Circuit Terminal Block Wiring Procedure
1.
Remove the terminal cover.
2.
Remove the screws that attach the conduit bracket and remove the conduit bracket from the drive.
A - Conduit bracket
3.
Put the end of a straight-edge screwdriver into the center hole and move it up and down to remove the knock-
out hole.
WARNING
pressure on the circular metal plates, they can eject and cause injury.
YASKAWA TOEPC71061732E HV600 Drive Installation & Primary Operation
Figure 7.13 Tighten the Terminal Block Bolts
Figure 7.14 Remove the Conduit Bracket
Injury to Personnel. Carefully move the screwdriver to remove the knock-out holes. If you use too much
7 Electrical Installation
41