Maintenance; Troubleshooting - YASKAWA HV600 Series Installation & Primary Operation

18 Maintenance

18 Maintenance
Refer to the Maintenance & Troubleshooting Manual (TOEPYAIHV6001) for more information.
Only let authorized persons do maintenance, examine, or replace components on the drive.
Read this manual carefully and know all the precautions and safety information before installing, wiring, repairing, or
examining the drive or replacing components.
Examine and maintain the drive and peripheral devices regularly to extend the life of the drive and decrease
performance deterioration, decrease early wear, and decrease drive failures.
Regular examinations and maintenance will also decrease system downtime.
Refer to the Technical Reference (SIEPC71061732) for more information about maintenance and examinations.
Examine the drive one time each year at a minimum.
The operating conditions, environmental conditions, and use conditions will have an effect on the examination
frequency for connected equipment.
Examine the drive more frequently if you use the drive in bad conditions or in these conditions:
• High ambient temperatures
• Frequent starting and stopping
• Changes in the AC power supply or load
• Too much vibration or shock loading
• Dust, metal dust, salt, sulfuric acid, or chlorine atmospheres
• Unsatisfactory storage conditions.
The drive has Maintenance Monitors that monitor component wear and give warnings when the performance life
estimate is approaching. When you use the maintenance monitors, you remove the need to shut down all system
components when you have problems. Refer to these monitors:
• U4-04 [Cool Fan Maintenance]
• U4-05 [CapacitorMaintenance]
• U4-07 [IGBT Maintenance]
You can set alarm notifications to inform you about the maintenance periods for specific drive components. Refer to
these Maintenance setting parameters:
• o4-04 [Fan Maintenance Time]
• o4-05 [Capacitor Maintenance Setting]
• o4-07 [Softcharge Relay Maintenance Set]
• o4-09 [IGBT Maintenance Setting]
• o4-10 [IGBT Maintenance Time]
19

Troubleshooting

Refer to the Maintenance & Troubleshooting Manual (TOEPYAIHV6001) for more information.
If the drive or motor do not operate correctly, look at the drive keypad for fault and alarm information.
• For drive faults:
– The keypad shows the fault code.
– When o2-24 = 0 or 1 [LED Light Function Selection = Enable Status Ring & Keypad LED or LED Status Ring
Disable], and ALM/ERR on the LED Status Ring illuminate continuously.
– The drive shuts off output and the fault relay output activates. The motor coasts to stop.
• For drive alarms:
– The keypad shows the alarm code.
– When o2-24 = 0 or 1,
98
and ALM/ERR on the LED Status Ring flash.
YASKAWA TOEPC71061732E HV600 Drive Installation & Primary Operation