YASKAWA HV600 Series Installation & Primary Operation page 36

7 Electrical Installation
The procedures to wire the main circuit terminal block are different for different drive models. Refer to
procedures by drive model.
Table 7.2 Types of Wiring Procedure for the Main Circuit Terminal Block
Model
2011 - 2059
4005 - 4065
2075 - 2114
4077 - 4124
2143, 2169
4156
2211 - 2273
4180 - 4302
■
Notes on Wiring the Main Circuit Terminal Block of Models 2011 to 2059 and 4005 to 4065
Read these safety messages and notes before you wire the main circuit terminal block.
WARNING Fire Hazard. Do not use bent or crushed wires. Remove the damaged end of the wire before you use it. Incorrect
connections can cause death or serious injury from fire.
WARNING Fire Hazard. If you use stranded wire, make sure that all of the wire strands are in the connection. Also, do not
twist the stranded wire too much. Incorrect connections can cause death or serious injury from fire.
NOTICE
Do not solder stranded wire. Soldered wire connections can become loose over time and cause unsatisfactory
drive performance.
NOTICE
If you use power tools to tighten the terminal screws, use a low speed setting (300 min
min)). High speeds can cause damage to the terminal screws.
NOTICE Do not tighten the terminal screws at an angle of 5 degrees or more. Incorrect positioning can cause damage to
the terminal screws.
36
IP20/UL Type 1 or IP20/UL Open Type
Procedure Reference
Procedure A
Procedure B
Procedure C
Procedure D
Figure 7.3 Permitted Angle
Procedure
38 Procedure E
39 Procedure F
41
43
YASKAWA TOEPC71061732E HV600 Drive Installation & Primary Operation
Table 7.2
IP55/UL Type 12
Reference
45
46
-
-
-1 (r/min) to 400 min -1 (r/
for