YASKAWA HV600 Series Installation & Primary Operation page 42

7 Electrical Installation
4.
Use a file to make the rough surface of the knock-out hole edge smooth.
5.
Put the conduit bracket in its initial position.
6.
Remove the terminal block bolt.
A - Bolt
7.
Put the ends of wires with closed-loop crimp terminals through the conduits.
Note:
Install the included rubber grommets or use conduits to keep the IP20 protection level and to prevent damage to the wires. To
comply with UL standards, you must use conduits for wiring.
42
Figure 7.15 Reattach the Conduit Bracket
Figure 7.16 Remove the Terminal Block Bolts
YASKAWA TOEPC71061732E HV600 Drive Installation & Primary Operation