Objects For Network Settings - Festo CPX-E-EP Translation Of The Original Instructions

Parameterisation
Object type
CPX-E-specific objects for
parameterisation of Force,
Fail safe and Idle mode
1) decimal
Tab. 13 EtherNet/IP Object Classes
Counting mode
For the module-orientated objects, the following applies: instance number = module number + 1
– The modules are counted starting at 0 for the bus module.
– The instances are counted starting at 1 for the bus module.
An overview of the available data and parameters, their function numbers as well as their assignment
to the objects can be found in the following sections.
The description and mode of operation of the individual parameters and data as well as fundamentals
of parameterisation can be found in the "Description of automation system CPX-E"
è 1.1 Applicable Documents.
3.1.2

Objects for Network Settings

Device Level Ring Object
– Object class: 71
d
– Instances: 1
Status information for the Device Level Ring protocol (DLR protocol).
Attribute no. Access
1 Get
2 Get
3 Get
Festo — CPX-E-EP — 2020-01a
Object Instances
class
1)
131 1 48
...
Description
Network topology
0 = linear
1 = ring
Network status
0 = Normal
1 = Ring fault
2 = Unexpected loop detected
3 = Partial network fault
4 = Rapid fault/restore cycle
Ring supervisor active status flag
0 = Backup supervisor
1 = Active ring supervisor
2 = Normal ring node
3 = Non DLR topo
1)
Name
Function output idle mode
object
Detailed
information
3.1.7 Fail
è
Safe and
Idle
Parameters
Type
USINT
USINT
USINT
21