Menu [Settings] - Festo HSP AE Series Manual

4. The control panel
4.5

Menu [Settings]

} Settings
HSP Setup
HSP mode
Position set
Count direction
Delivery status
HM type
Password edit
Menu command
[HSP Setup]
[HSP mode]
[HSP Setup]
[Position set]
[HSP Setup]
[Count direction]
[HSP Setup]
[Delivery status]
1)
[HM type]
[Password edit]
1)
Only for service personnel. Not contained in version V−HM 1.20.
Tab. 4/4: Menu [Settings]
Festo P.BE−HSP−AE−IO−EN en 0510NH
Warning
Damage to or impairment of the mechanical components
In all teaching procedures the motor turns or the
connected handling module starts to move.
Make sure that:
·
nobody can place his/her hand in the positioning
range of the handling module
there are no objects in the positioning range.
The menu [Settings] contains all the functions necessary for
parametrizing and commissioning the drive (see Tab. 4/4).
Further information on the individual menu commands can be
found in the chapters specified.
Description
Teaching typical pick and place sequences
Editing the positioning set table
Reversing the count direction of all positions
All settings undertaken in [HSP Setup] and all positioning sets
are reset to the factory settings.
Selecting the handling module according to device type
(e.g. HSP−...) for adapting the device parameters and the setup
functions.
Setting up a local password with 3 figures for the control panel
Chapter
4.5.1
4.5.2
4.5.3
4.5.4
4.5.5
4.5.6
4−13