Product Labelling; Specified Standards; Ul/Csa Certification - Festo CPX-E-EP Translation Of The Original Instructions

About this Document
Appropriate software for determining the product version can be found in the Festo Support Portal
è www.festo.com/sp.
Information on using the software can be found in the integrated Help function.
There may be an updated version of this document for these or later product versions
è www.festo.com/sp.
1.4

Product Labelling

The product labelling is located on the left-hand side of the module. Scanning the printed Data Matrix
Code with an appropriate device opens the Festo Support Portal, with the information appropriate for
the product. Alternatively, the Product Key (11-digit alphanumeric code on the product labelling) can
be entered in the search field of the Support Portal è www.festo.com/sp.
Fig. 1 Product labelling
1.5

Specified standards

Version status
EN 60529:2013-10
EN 61000-6-2:2005-08
EN 61000-6-4:2007-01
Tab. 3 Standards specified in the document
1.6

UL/CSA Certification

In combination with the UL inspection mark on the product, the information in this section must also
be observed in order to comply with the certification conditions of Underwriters Laboratories Inc. (UL)
for USA and Canada.
6
1 Identifier
2 Revision version
3 Data Matrix Code
4 Pin allocation
5 Approvals/warning symbols
6 Product key
7 MAC-ID
8 Part number/serial number
IEC 60204-1:2014-10
IEEE 802.3:2014-00
NE 21:2012-05
Festo — CPX-E-EP — 2020-01a