Festo CPX-E-EP Translation Of The Original Instructions page 37

Parameterisation
Attribute no. Access
2 Get
3 Get/Set
4 Get/Set
5 Get/Set
6 Get/Set
7 Get/Set
8 Get/Set
9 Get/Set
Festo — CPX-E-EP — 2020-01a
Description
Status of diagnostic memory (bit 0, 1)
0 = Recording active
1 = Recording inactive
Clear_trace1, access via EDS
Clear_trace2, access via explicit mes-
saging; confirmation of execution by
resetting (0) the attribute value
Entries saved retentively with Power On
(bit 0)
0 = active (default)
1 = inactive
Run/stop filter 1 (bit 1)
0 = Save the first 40 entries, stop after 40
entries
1 = Save the last 40 entries, overwrite
existing entries (default)
Run/stop filter 2 (bit 0
0 = Run/stop filter 2 inactive (default)
1 = Record up to the defined error num-
ber (FN)
2 = Record up to the defined FN + module
number (MN)
3 = Record up to the defined FN + MN +
channel number (KN)
4 = Record from the defined FN
5 = Record from the defined FN + MN
6 = record from the defined FN + MN + KN
7 = Reserved
Error end filter (bit 3)
0 =Filter inactive, record running errors
(end of error) (default)
1 = Filter active, do not record running
errors (end of error)
Error number filter (bit 4, 5)
0 = Filter inactive (default)
1 = Record only defined error numbers
2 = Do not record defined error numbers
3 = Reserved
Type
BYTE
BYTE
BYTE
BYTE
BYTE
2) BYTE
...
BYTE
BYTE
Function
number
3483 (bit 0,
1)
3480 bit 0)
3480 bit 1)
3484 (bit
0 2)
...
3484 (bit 3)
3484 (bit 4,
5)
37