Labels - Guardian Fall Protection Beamer 2000 Instruction Manual

Labels

Beamer Anchor
Part #:
WARNING! READ CAREFULLY BEFORE USING
MANUFACTURER'S INSTRUCTIONS INCLUDED AT
TIME OF SHIPMENT MUST BE FOLLOWED AT ALL
TIMES FOR PROPER USE, MAINTENANCE, AND
INSPECTION. ALTERATION, ABUSE , OR MISUSE OF
THIS PRODUCT MAY RESULT IN SERIOUS INJURY OR
DEATH. DO NOT REMOVE LABELS.
MADE IN TAIWAN
Inspection Grid:
Inspect prior to each use. Competent Person must
inspect and record at least every 12 months.
ANSI Z359.18-17, ANSI A10.32-12, OSHA 1910,
and OSHA 1926 Subpart M.
Type A anchorage connector.
Maximum 1 connection per Beamer Anchor.
Capacity range: 130 - 420 lbs.
5,000 lb. MBS (minimum breaking strength).
Minimum service temperature: -30º F.
Always use with compatible equipment, possibly
including special lanyard for tie-off at foot level.
MAKE ONLY COMPATIBLE CONNECTIONS.
FOR USE ON STRUCTURAL STEEL I AND H BEAMS ONLY.
Adjust Beamer Anchor at every junction or flange
dimension change.
*Serial # and date of manufacture engraved on Beamer Anchor High Strength Bar.
7
85082 (Rev. I)