Intercoax ECP-2808RM User Manual page 16
Ethernet over coax / utp managed receiving switch
Hide thumbs
Also See for ECP-2808RM:
- User manual (41 pages) ,
- Quick installation manual (4 pages) ,
- User manual (22 pages)
Table of Contents
Advertisement
Next, you need to install the second prerequisite, the SSCE Runtime software.
There are two options, 32-bit (x86) and 64-bit, depending on your Operating System.
When in doubt, start with running the 64-bit installer:
If an error shows up explaining your Operating System does not support x64 software, use the other installer:
Follow the instructions in the installer to finish the installation.
After having installed the necessary prerequisites, we can start installing ECP Manager itself.
Start by going into the 'ECPManager folder':
Next, run the installer software for ECP Manager:
Select the 'Install' option:
Management Software Configuration — 16
Advertisement
Table of Contents
Need help?
Do you have a question about the ECP-2808RM and is the answer not in the manual?