Table of Contents
Advertisement
Introduction
Important Messages and Requirements
1-6
DIP switch settings must be handled with special care to prevent any damage to
IMx-T unit:
·
Do NOT change DIP switch settings while the IMx-T unit is powered-up, as
this may cause damage and void warranty.
Before powering up the IMx-T unit, make sure that DIP switch settings are
·
properly set to match the recommendations for the connected sensors.
Incorrect settings may cause permanent damage to the IMx-T unit.
IMx-T is a Class A equipment intended for use in an industrial environment.
SKF Multilog On-line System IMx-T
User Manual, Revision F
Advertisement
Table of Contents
Need help?
Do you have a question about the Multilog On-line System IMx-T and is the answer not in the manual?