Trip Distance; Setting The Odometer; Recording And Viewing Performance Data - Intellitronix B-9999 Installation Manual

trip, the speedometer should read something other than 0 MPH. If it does not change, return and
locate the problem before continuing. Otherwise, proceed with the calibration.
2. Stop at the beginning of the measured mile with your vehicle running and in odometer
mode (NOT trip mode), press and hold the push-button until the odometer displays 'HI-
SP'. On its own, the gauge will then cycle through the recorded performance in the
following order: '0 – 60', '1/4', 'ODO', and 'CAL'.
3. While 'CAL' is displayed, quickly tap the push-button once. This will put the
speedometer in Program Mode. If you did not tap while 'CAL' is displayed, the pulses
per mile will be displayed on the odometer and the display will go back to MPH mode.
Otherwise, you will now see 'CAL' displayed along with the number '0'. This indicates
that the microprocessor is now ready for calibration.
4. When you are ready, begin driving on the metered mile. You will notice that the reading
will start counting up. The odometer will begin to display the incoming pulse count.
Drive the vehicle through the measured mile (speed is not important, only the distance
traveled).
5. At the end of the mile, stop and press the push-button again. The odometer will now
display the new number of speedometer pulses that were registered over
the distance. The odometer will continue to display the pulse reading for a few seconds.
Once it reverts to the default mode, you have successfully calibrated your speedometer.
Warning: If, while in 'CAL' mode, you do not move the vehicle and press the button
again, the microprocessor will NOT have received any data and the unit will display
'Err' and will revert to the factory settings. At a minimum, drive some distance and
return to the start if necessary. If you miss stopping the display at 'CAL', simply repeat
the steps.

Trip Distance

A single tap of the recall button will activate the trip meter in the odometer display. A decimal
point will appear which will indicate that you are in trip meter mode. Holding the recall button will
clear out the trip distance. To return to the default odometer display, tap the recall button again.
The decimal point will disappear, indicating that you are back in the default odometer display.

Setting the Odometer

While scrolling through 'CAL' mode you will see 'ODO' appear. This will allow you to enter the
vehicle's actual mileage. Press the trip button again at this point and you will enter the odometer
set up mode. Press quickly to change the number of the digit on the right. Press and hold to
advance to the next digit. Do this for all 5 digits. For Example: To enter the mileage reading 23456
into the odometer, at the 'ODO' prompt, tap the small black button (quickly) two times, until the
number 2 is displayed. Then press and hold the button until the numbers 20 are displayed. Tap the
button 3 times until 23 is displayed. Press and hold the button until 230 is
displayed, and continue in this manner until 23456 is displayed. The speedometer will advance to
the home screen, five seconds after the last number is entered.

Recording and Viewing Performance Data

Follow these steps to record and recall Performance Data (high speed, ¼mile ET, and 0-60 time):
1. Before each run, your car must be at a complete stop at the starting position. Press and hold
the push-button as it cycles through the performance data. At the end, the odometer will
4 - B-9999 Intellitronix
(rev.07/2018)
www.intellitronix.com