Advertisement
Quick Links
Made in America
Thank you for purchasing this instrument from Intellitronix. We value our customers!
INSTALLATION GUIDE
Chevrolet Bel Air Dash Panel
Part Number: DP1101
Year Series: 1955-56
* Always disconnect the battery before attempting any electrical work on your vehicle.*
*Power up the unit before installing to ensure everything is working properly*
KIT COMPONENTS
One (1) Digital Circuit Board (with Speedo-Tach Combo, Voltmeter, Water Temp, Oil Pressure
and Fuel Gauges)
One (1) Smoked Acrylic Lens
Peel off protective covering from both sides
Two (2) Sending Units: (1-S8013 - water temp. & 1-S8868 oil pressure)
1/8" NPT, 1/2" NPT Bushing
One (1) GM Universal Speedometer Sensor (S90l3)
7/8" NPT Industry Standard threads
One (1) Mounting Kit:
(6) #4 - 1" recessed Phillips head screws
(6) ½" nylon spacers
DASHBOARD REMOVAL AND INSTALLATION
Disassembly
1. Remove the existing dash cluster from the vehicle. Separate the front bezel from the back housing
and gauges. (You will not need to re-use the back housing.)
2. Remove the bezel from the old assembly.
3. Attach the acrylic lens to the front of the panel, using provided mounting
4. Attach the new panel to the rear of the bezel, re-using the original screws and other
hardware.
5. Wire the gauges and sending units to the panel as indicated by the instructions below.
1 | DP1101
Lifetime Guarantee
1192024
(6) #4 Nylock nuts
(6) #4 Flat washers
kit.
www.intellitronix.com
Advertisement
Related Manuals for Intellitronix DP1101
Summary of Contents for Intellitronix DP1101
- Page 1 Made in America Lifetime Guarantee Thank you for purchasing this instrument from Intellitronix. We value our customers! INSTALLATION GUIDE Chevrolet Bel Air Dash Panel Part Number: DP1101 Year Series: 1955-56 * Always disconnect the battery before attempting any electrical work on your vehicle.*...
-
Page 2: Wiring Instructions
This wire is an optional wire some vehicles may not require. Brown – High Beam Connect the brown wire on the Dash unit to your high beam headlight circuit. This wire is powered on when the high beam is turned on and receives 12 volts. 2 | DP1101 1192024 www.intellitronix.com... - Page 3 Vehicle vin or Model and year and Consult your factory Pinout Chart. Speedometer - White (Intellitronix Speed Sender to replace factory cable drive) - Disconnect the mechanical speedometer cable from the transmission and insert the new electronic sensor into the transmission.
- Page 4 Programming/Recall Button – Grey There are two long grey wires connected to the push- button on the board. Mount the recall button in a convenient location such as under the steering column so that you may easily have access to your programming functions. 4 | DP1101 1192024 www.intellitronix.com...
-
Page 5: Display Function
However, once it finishes scrolling one time, the memory is ready to record new data and will begin recording again once the vehicle starts to move. The highest speed measured over multiple runs will be retained in memory. 5 | DP1101 1192024 www.intellitronix.com... - Page 6 The odometer will continue to display the pulse reading for a few seconds. Once it reverts to the default mode, you have successfully calibrated your speedometer. 6 | DP1101 1192024 www.intellitronix.com...
Need help?
Do you have a question about the DP1101 and is the answer not in the manual?
Questions and answers