Binding; Binding The Aircraft And St16S; Binding The Aircraft And Ion L1 Pro; Takeoff - YUNEEC TYPHOON H3 User Manual

Binding

Binding the aircraft and ST16S

NOTICE: The aircraft and ST16S Ground Station are already bound out of factory. There is no need to
bind them. Pilot can follow the steps below if binding is needed.
STEP 1: Power on the TYPHOON H3. After initialization completes, the two LEDs on rear arms will blink
blue.
STEP 2: Lift the aircraft upside down until all LEDs blink yellow quickly, and then turn the aircraft back
on straight and level ground.
STEP 3: Switch on the ST16S Ground Station. Wait a few seconds for all systems to be boot up.
STEP 4: Tap the settings icon [
slid to the "Drone" selection.
STEP 5: Tap the refresh icon [
receiver listed in the column. Wait until a tip pops up to indicate the binding is completed.

Binding the aircraft and ION L1 PRO

Step 1.
Switch on the ST16S followed by the TYPHOON H3 aircraft.
Step 2.
Tap the[ ]on the top right corner on the main interface of
ST16S, then tap the[
Step 3.
Tap the serial number of the ION L1 PRO when the following
window pops up. (If multiple Yuneec UAS are used,check the ID
number on the side of each camera to assure correct camera se-
lection/binding).
Step 4.
Using the password "1234567890" , authorize the camera and tap
"OK" to con rm.
NOTICE: If the connection process is delayed, close the pop up
window and then repeat the above steps.

Takeoff

Option 1

Press and hold the START/STOP button until the aircraft boot up.
Step back approximately 26 feet (8 meters) behind TYPHOON H3.
When there is suitable GPS signal for both the ST16S Ground Sta-
tion and TYPHOON H3, slowly raise the left-hand stick to slightly
above the center position. The aircraft will take off and climb slowly
(or raise the stick further until it does). Allow the stick to return to the
center position when the aircraft reaches the desired altitude.
] on the right top corner of the ST16S. Select the icon [
]，and then tap OK to unbind RC link. Select the corresponding
]on the switching interface.
11
] and
GPS
9
VOL
12.6V
FSK
FSK
WiFi
WIFI
CHA
POS
CHA
IONL1P
IONL1P
POS
IONL1P
00 : 35 : 25
IONL1P
Roll 120˚
System Settin