Follow Me; Watch Me; Journey - YUNEEC TYPHOON H3 User Manual

Follow Me

The Follow Me function allows TYPHOON H3 to
follow the pilot, adjusting its location to the loca-
tion of the ST16S Ground Station. This function is
enabled when ST16S's GPS positioning has been
acquired, and TYPHOON H3 is using shared GPS
signal with the ST16S Ground Station.

Watch me

Watch me enables the camera to keep tracking the
remote controller no matter where and how it
moves as the camera can automatically tilt its
angle according to the controller.
Press the Icon[ ], and it will turn green[
Follow me displayed in the right bar will display
'Watch Me'.
NOTICE: When the Watch/Follow mode is enabled
the drone will enter the Headless ight control mode.
you need towards the drone all the time to get the
correct direction control.
When executing Watch Me function, we
NOTICE:
suggest you switch the gimbal tilt mode to angle
mode and gimbal pan mode to follow mode, then
position the gimbal tilt slider and gimbal pan knob to
the centre position,to make sure the pilot are in the
centre of the video, or you can use the gimbal tilt
slider and gimbal pan knob as a trim of your gimbal
angle.

Journey

Journey function enables TYPHOON H3 to capture
the perfect aerial sel e or any scenic shot much
easier and faster. Depending on the pilot's desired
setting, TYPHOON H3 will go up, out and return.
Tap Journey to enter the journey function.
Distance can be adjusted manually between 32.8ft
and 295.3ft, and speed between 3.3 ft/s and 32.8
ft/s.
: Taking photos or recording video can be
switched by tapping [ ] and [ ] icons.
].
21
Journey
Distance
98.4 ft
32.8 ft 295.3 ft
Speed
32.8 ft/s
3.3 ft/s 32.8 ft/s