Landing - YUNEEC TYPHOON H3 User Manual

V. If it's the rst time you bind the slave remote to
the mast remote , please tap the Accept button on
the mast remote screen.
VI. Bind nished
Master remote
NOTICE: Tap Stop Team Mode Button you can exit team mode ,no matter on the Master remote or
the Slave remote
VII. Operation Method
1. Master remote can only control the drone , can't
control the gimbal and camera.
2. Tap the gimbal operation method select button ,
you can select the gimbal operation mode
2.1Same with the single remote mode
2.2 Joystick control mode, drone pitch joystick
controls the gimbal tilt; drone roll joystick controls
gimbal pan direction.

Landing

There are three ways to land the aircraft:
1. Position the TYPHOON H3 above the area where you would like to land. Lower down the retract-
able landing gear, and then slowly lower the left-hand stick to below the center position. TYPHOON
H3 will descend slowly and land.
2. Activate Home Mode and TYPHOON H3 will automatically y itself back to the home point and
land.
3. Press the icon ( ), then slide the sliding block, and the aircraft will land automatically.
WARNING: Always land as soon as possible after the rst low level voltage battery warning, or land
immediately after the second level low voltage battery warning by the Motor LED Status Indicators
ashing rapidly.
Slave remote
23