Remote Controller; St16S Charging; Flight Control - YUNEEC TYPHOON H3 User Manual

After Landing
ALWAYS turn off TYPHOON H3 BEFORE turning off the ST16S Ground Station. Then remove the bat-
tery from TYPHOON H3 and allow it to cool to ambient/room temperature before recharging.
NOTICE: If the signal of the remote control is lost, TYPHOON H3 will automatically return to the home
point and hold its position (with a suitable GPS signal/lock) over the home position (except for low
battery).

Remote Controller

ST16S Charging

Charge the ST16S battery by using supplied USB cable and inserting it into the Micro USB port on the
charger. It will take approximately ve hours to charge a fully discharged battery.
WARNING: Do not leave the battery in the charger after the battery is fully charged.

Flight Control

The default ight control is known as Mode 2. The left stick controls the aircraft's altitude and head-
ing, while the right one controls its direction movements.
Turn Left Turn Right
Forward
Backward
Up
Left Right
Down
24